Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84247members
353346posts

FAQ_ Vigilohm System + Com'X510 wiring

Metering & Power Quality

Collaborate with multiple experts and discuss various topics about Power Meters and Power Quality. From design & implementation to troubleshooting and more, get support from experts and share your experiences by subscribing to the Schneider Electric Exchange forum today.

Madleen_Laclef
Lt. Commander Lt. Commander
Lt. Commander
0 Likes
0
150

FAQ_ Vigilohm System + Com'X510 wiring

Document below describes how to wire a system made of Energy Server Com’X510 and  Vigilohm interface XLI300 or XTU300.

 

This document was initially intended to build a democase with these devices (simulation of network Resistance and Capacitance). 

 

Word document: Vigilohm and Com'x case.docx - Box

Visio diagram: Vigilohm and Com'x Case.vsd - Box

 

Note: Presentation on the benefits of architecture with Com'X510 and Vigilohm is available here.