Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Hello All,
We had a request from one of our customer, whether we can connect CT's in the below method for Accuisne installations.
Yes it is possible, If we wired properly, in series with proper polarity with sufficient CT burden and with appropriate wire gauge it will work.
Important recommendation to our customers/contractors, please be very clear on your requirement, try to get connect with the Country offer team , Local Application Engineering team or Global competency center, on selection of CT's , wire gauge and for proper connection.
By taking care of all the above aspects, it will be quite easy for our technician to complete the installation's and commissioning in a single shot.
Basically, if done properly it works.
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.