Com'X 510 Firmware v3.0.6 - Unable to create Custom Events

Miguel_Angelo · ‎2016-04-27

Hi

with the latest firmware version i get an error when the active custom events.

Best Regards

Miguel Gonçalves

sesa12529_bridg · ‎2016-04-27

To activate Events you need to first enable Schneider Electric Services in the Settings page.

Events require Remote Service Platform (RSP) to be activated. In versions before 3.0.6 this activation was done at boot time and was a major contributor to the long boot time of the Com'X 510. In order to reduce the boot time for initial configuration, RSP is no longer activated by default on initial boot. RSP will be activated whenever Schneider Services is enabled. Once Schneider Services is enabled RSP will be activated at boot time in subsequent restarts.

See Answer In Context

sesa12529_bridg · ‎2016-04-27

To activate Events you need to first enable Schneider Electric Services in the Settings page.

Events require Remote Service Platform (RSP) to be activated. In versions before 3.0.6 this activation was done at boot time and was a major contributor to the long boot time of the Com'X 510. In order to reduce the boot time for initial configuration, RSP is no longer activated by default on initial boot. RSP will be activated whenever Schneider Services is enabled. Once Schneider Services is enabled RSP will be activated at boot time in subsequent restarts.

Miguel_Angelo · ‎2016-04-27

Ok

Miguel Gonçalves