Schneider Electric support forum to share knowledge about product selection, installation and troubleshooting for EcoStruxure Panel Server, PowerTag, Com'X, Link150…
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2019-09-1502:19 AM
Calibrating Custom Analog Sensor for Com'X 210
Hi,
Configuring the 4-20mA analog input for a Com'X, a custom sensor device type was configured. The 'Lower bound' was set to 0 (L/s) and 'Upper bound' set for 20 L/s. Didn't find any reference to these fields in the user manual.
Does this mean Com'X data will scale linearly between the values of 0 and 20 for input currents of 4mA to 20 mA?