EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-14 01:19 AM
Hi team,
I have an external wired temperature probe connected to a NMC in a Smart-UPS SRT 5000 and we do not see this sensor in IT Expert. In DCE we see the sensor properly and also in the UPS's web page, but not in IT Expert.
Regards
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-08-12 12:30 AM
Hi Jzurera
IT Expert uses a different protocol for data communication than DCE. The reason for this difference is that IT Expert needs data alignment for the cloud analytics. In some cases like yours the data from the external sensor is not recognized and therefore not shown.
If you could send me more information on the temp probe we can investigate the data format.
Regards
Bjarke
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.