Subscribing is a smart move!
You can subscribe to this forum after you log in or create your free account.
Sensor description in mobile app
EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
This question was originally posted on DCIM Support by Davide Manassi on 2018-12-05
Hi.
I see that on mobile app the data reported from sensor controlled by a Netbotz appliance disply only the pod name but some sensor are not connected directly to the Netbotz but could be controlled via SNMP or IPMI protocol. So in mobile app I see a lot of sensor data but I cannot understand correct sensor reference, for example I see battery age or battery voltage but I know that it referred to an UPS, but label of UPS is not displayed. For example this is what I see on NetBotz Advance View configuration:
and this the correspondance on mobile APP:
I aspect that instead appear Office_CED under Battery Age on mobile app the correct label must be APC04.
in the past app release this is displayed correctly.
Regards.
Link copied. Please paste this link to share this article on your social media post.
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.