Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84323members
353487posts

RFCODE modbus

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
213

RFCODE modbus

This question was originally posted on DCIM Support by Bill Gentry on 2019-08-29


How do I add Modbus RFCode sensors from Center Scape into DCE ver7.6?

 

(CID:148344173)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
213

Re: RFCODE modbus

This answer was originally posted on DCIM Support by Mike Stacey on 2019-08-29


RFcode do not have a standard Modbus register map. Each customer install has a different register count for sensor. I would be happy to assist you in obtaining a custom DDF for your Center Scape. 

Please feel free to email me at mike.stacey@se.com

(CID:148344191)

DCIM_Support
Picard
Picard
0 Likes
0
213

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.