PX100 NMC with Modbus RTU

[DCIM_Support]

I was looking to get a NMC Card with Modbus RTU like the AP9635 however I believe the PX100 does not like using this extra card in the Smart Slot. Can someone confirm that?

If that is the case, is there a compatible NMC with Modbus RTU connections? If not, I will have to fall back to Modbus TCP.

Regards,

J

(CID:149783527)

[DCIM_Support]

Dear John Smith,

Please tell us, were you able to solve your question or not?

With respect.

(CID:151062354)

[DCIM_Support]

No, I have not answered it yet. According to a compatibility matrix i found, it should work.  But it appears the AP9635 re flashed with the sy3p v6.5.0 firmware does not allow the card to be programmed by the front display.

(CID:151062977)

[DCIM_Support]

to clarify:

...does not allow the AP9635 card to have it's IP information changed or viewed by the front display.

(CID:151064176)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.