Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Recommended Forums
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
I have a new setup with NetBotz 750. The question is that, how can I configure the sensors?
In the NetBotz 250, 570 systems I can configure each sensor which is connected to the system. I haven’t find that kind of settings in the NetBotz 750. I can rename the sensor pods and the sensor.
I get the reading that the dry connect sensor is open.
The question is that, how can I setup the sensors normal state (NO or NC)?
Where can I see the connected POD serial numbers?
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
I have found the settings. The solution if anybody needs it.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.