EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-06 01:08 AM
This question was originally posted on DCIM Support by COATANEA Jerome on 2020-01-22
Hi,
I have to replace a nebotz 200 by a new nebotz 250. I would like to keep the same configuration as i already have pods and sensors connected to this device. May i use the config file from the 200 to update the 250 ? Is it possible ? or is there any limitations ?
Thank you !
Jerome
(CID:153945280)
Posted: 2020-07-06 01:08 AM
This answer was originally posted on DCIM Support by GavOB on 2020-01-22
Hi COATANEA Jerome,
I don't believe this is possible as the Netbotz 250 is based on a newer platform to the previous versions.
-Gavan
(CID:153945285)
Posted: 2020-07-06 01:08 AM
This comment was originally posted on DCIM Support by Steven Marchetti on 2020-01-22
Some of the settings may work but anything having to do with specific sensors or pods likely will not.
(CID:153945339)
Posted: 2020-07-06 01:08 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.