Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84805members
354261posts

MGE Upsilon STS 250 snmp oid

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
145

MGE Upsilon STS 250 snmp oid

This question was originally posted on DCIM Support by Darius Znamerovskis on 2017-04-26


hello, we have MGE Upsilon STS 250 installation whit 66074 communition card.

http://www.apc.com/shop/au/en/products/MGE-SNMP-Web-Card/P-66074

in DCE this unit use mge ups ddf not a mge sts ddf.

do i need sam additional setup for 66074?

(CID:116924812)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
145

Re: MGE Upsilon STS 250 snmp oid

This answer was originally posted on DCIM Support by Mohan Gowda G S on 2017-04-26


Hello Darius,

Normally it does not require any additional set up, just connect the card to the slot and discover the device in DCE and that should work fine.

Please let us know if you have any problems in viewing the parameters in DCE.

Thanks and Regards, 

Mohan Gowda

(CID:116926245)

DCIM_Support
Picard
Picard
0 Likes
0
145

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.