EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-06 01:11 AM
This question was originally posted on DCIM Support by Victor Juarez Velazquez on 2020-01-23
Three questions:
2. Is there any way to link the Inrow communcication card to DNP3 protocol ?.
3. Have you tested a gateway such as FieldServer to joint both of them ?
(CID:154403142)
Posted: 2020-07-06 01:11 AM
This answer was originally posted on DCIM Support by Steven Marchetti on 2020-01-23
Hi Victor,
Neither the DCE nor the InRow units use the DNP3 protocol. I've searched the web and there do appear to be some protocol converters available for DNP3 to modbus. I can't speak to the specifics as I've never dealt with DNP3 but perhaps others on this forum can provide a more hands-on, detailed suggestion.
Thanks,
Steve
(CID:154403155)
Posted: 2020-07-06 01:11 AM
This answer was originally posted on DCIM Support by Glenn Martin on 2020-01-24
Hi Victor,
DDFs for DCE7 have been developed in the past for Fieldserver devices over SNMP, though I couldn't say for sure whether any of those Fieldserver devices were translating from DNP3 protocol.
You may find results for Fieldserver if you search at ddf.ecostruxure.com, however, these are bespoke DDFs intended for a particular customer's configuration and will probably not work for your device. Your best option is to start a new request directly.
Regards,
Glenn Martin
(CID:154403622)
Posted: 2020-07-06 01:11 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.