Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84589members
353854posts

How to add standalone devices (e.g. DS8886) into the DCO layout?

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
3
214

How to add standalone devices (e.g. DS8886) into the DCO layout?

This question was originally posted on DCIM Support by Krzysztof Kęsicki on 2017-04-11


hi,

When I found some standalone devices in DCO genome library and I want to move them to the layout - I can't do that!

Is there any possibility to move particular genome (eg. DS8800 or System Z10) without any changes and put it directly on the rised floor?

 

BR,

Krzysztof 

(CID:116919364)

3 Replies 3
DCIM_Support
Picard
Picard
0 Likes
0
214

Re: How to add standalone devices (e.g. DS8886) into the DCO layout?

This answer was originally posted on DCIM Support by Jef Faridi on 2017-04-11


Hi Krzysztof,

You are right, it seems those devices currently cannot be modeled as floor standing units. That seems to be a genome bug and I will register an enhancement case for it.

As a current work around, you might want to use/customize another asset from the Genome Library (such as Generic Powered Floor Equipment), thanks.

Kind regards

(CID:116919390)

DCIM_Support
Picard
Picard
0 Likes
0
214

Re: How to add standalone devices (e.g. DS8886) into the DCO layout?

This answer was originally posted on DCIM Support by Devendra Honnappa on 2017-04-12


Hi Krzysztof,

We  have updated the form factor for the above Devices as Standalone. This changes can be updated by applying the Genome update file of next release (that is on end of April).

Thank you.

Regards

(CID:116919888)

DCIM_Support
Picard
Picard
0 Likes
0
214

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.