Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84805members
354261posts

How can I tell if my DCE online association is good?

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
187

How can I tell if my DCE online association is good?

This question was originally posted on DCIM Support by Chris Gray on 2018-10-30


I've just performed an update of our 7.5.x virtual appliance to v7.6.x.  Post update it was stating that I need to perform an online association, but the dialog box doesn't match what's actually seen in the Help screen of the desktop client.

After logging in, I do see this Virtual appliance underneath of my profile, but it's showing in red, not green as it did previously.  Does the color of the device have any bearing on it's status? If the device is showing underneath of my profile, is that good enough?

(CID:134691799)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
187

Re: How can I tell if my DCE online association is good?

This answer was originally posted on DCIM Support by Chris Gray on 2018-10-30


After switching the browser used by the desktop client to Firefox, I was able to perform an offline association and the version turned green on my devices under my profile.  I was getting stuck doing an offline association using IE because the drop down for the client version wasn't populating with any information.

 

(CID:134691843)

DCIM_Support
Picard
Picard
0 Likes
0
187

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.