EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 01:34 PM . Last Modified: 2024-04-04 12:28 AM
Is it possible to calculate PUE within Data Center Expert? If so, please share. If not, would I have to use DCO?
(CID:134691805)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 01:35 PM . Last Modified: 2024-04-04 12:28 AM
Hi Greg,
No, for PUE, you'll have to go with DCO. DCE does not have that option. If you have DCO, here's a bit of info on it:
Steve
(CID:134691815)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 01:35 PM . Last Modified: 2024-04-04 12:28 AM
Good to know, thank you! Now a question about DCO...can DCO pull devices from DCE so that you don't have to go into each of your field devices and point to another destination? or would how does DCO interact with DCE be a better question?
(CID:134691889)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 01:35 PM . Last Modified: 2024-04-04 12:27 AM
When configuring EE you are able to browse through the device list DCE exposes to DCO and select the power sensors to use measured data to calculate EE.
This page describes EE in more detail and has a video StruxureWare Data Center Operation: Energy Efficiency
Regards
Greg Sterling
(CID:134691922)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 01:35 PM . Last Modified: 2023-10-20 05:06 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.