How can I model Rack Air Containment in DCO

[DCIM_Support]

How can I model Rack Air Containment in DCO8?

Such as APC model numbers 

• ACCS1000—Rear containment for InRow RC or SC cooling units
• ACCS1001—Rear containment for NetShelter SX and InRow RP cooling units
• ACCS1002—End caps for any rear- or front-containment configuration
• ACCS1003—Front containment for InRow RC or SC cooling units
• ACCS1004—Front containment for InRow RP cooling units
• ACCS1005—Front containment for NetShelter SX enclosures
• ACCS1006—Rear containment for NetShelter SX 750-mm enclosures
• ACCS1007—Front containment for NetShelter SX 750-mm enclosures

Regards

(CID:118623444)

[DCIM_Support]

Hi Garry,

Hopefully I'm not disappointing you, but as far as I know currently modeling a simple rack (in DCO) is supported, not sure if using perforated tiles and/or the "Duct to ceiling" feature could be any help.

Kind regards

(CID:119049012)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.