EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-05 05:13 PM
This question was originally posted on DCIM Support by sheep on 2019-02-18
Hi everyone,
When I have a patch panel that all its ports are connected, means the panel is full of cables and no available ports at all.
Is there a way to know this before or after it happens? Or the only way to know it is manually enter the panel and see it?
Thanks !!
(CID:140218098)
Posted: 2020-07-05 05:13 PM
This answer was originally posted on DCIM Support by Jef Faridi on 2019-03-07
Hi Sheep,
There is no way to know this before or after it happens, you are right we need to manually check the patch panel(s). (ex. click on the patch panel in rack view, and check the port configurations in the Network management tab).
Kind regards
(CID:140711860)
Posted: 2020-07-05 05:14 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.