EcoStruxure IT GW: power factor sensors is absent for Symmetra PX250/500?
EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-0406:21 PM. Last Modified: 2024-04-0411:37 PM
EcoStruxure IT GW: power factor sensors is absent for Symmetra PX250/500?
Hi all!
Someone from the support team can explain why in EcoStruxure IT GW software (I have the latest version 1.3.3.2) for the Symmetra PX250/500 UPS's (the latest firmware of NMC2 is v.6.4.6) does not display power factor sensors?