Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84808members
354265posts

Does our DCE report can put custom info in the columns ?

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
4
216

Does our DCE report can put custom info in the columns ?

This question was originally posted on DCIM Support by Chu Li Wei on 2016-06-17


Hi All ,

Does our DCE report can put custom info in the columns ? Please see the screenshot as below

If the columns is fix , we can just see the IP of device and don't know the custom name of device in the report , that's would be an inconvenience for report review . Thanks .

Best Regards

(CID:106206970)

4 Replies 4
DCIM_Support
Picard
Picard
0 Likes
2
216

Re: Does our DCE report can put custom info in the columns ?

This answer was originally posted on DCIM Support by Steven Marchetti on 2016-06-17


Hi Chu Li,

 

You can add a custom property to either a summary report or a table report. You can not add a custom property to a graph report. For more information on this, please see k-base FA231521.

 

Thank you,

Steve.

(CID:106207026)

DCIM_Support
Picard
Picard
0 Likes
0
216

Re: Does our DCE report can put custom info in the columns ?

This comment was originally posted on DCIM Support by John Smith on 2016-06-17


I do not understand why these fields would not be available in the graph view but available in the others. Leave it up to the customer to decide if they want to see it or not. Just add the column configuration button.

Can this be a feature recommendation?

 

(CID:106209460)

DCIM_Support
Picard
Picard
0 Likes
0
217

Re: Does our DCE report can put custom info in the columns ?

This comment was originally posted on DCIM Support by Steven Marchetti on 2016-06-17


John, I have added this as an enhancement request. Since there is a note in the k-base however that this was a feature "by design" I would think there is a low likelihood that it will be added. In either cases, as with any enhancement request I can not promise this feature will make it into the product nor can I give you a timeframe. Steve

(CID:106209461)

DCIM_Support
Picard
Picard
0 Likes
0
217

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.