EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-04 09:47 PM
This question was originally posted on DCIM Support by Boris on 2018-08-15
Hello
I have connect DCO and DCE to NTP server .
If I need to do some activity ,when Daylight Saving Time Ends and the time turned backward 1 hour to ?
I'm meaning down the DB or operations and wait 1 hour or others activity ..
(CID:133371921)
Posted: 2020-07-04 09:47 PM
This answer was originally posted on DCIM Support by Steven Marchetti on 2018-08-15
Hi Boris,
For DCE, properly setting the locale and time zone under time settings:
...should allow DCE to show the proper time offset for both your region as well as daylight savings specific to that region. You do not need to adjust the server or stop any processes.
I believe it is similar in DCO but I will defer to the DCO experts on that.
Thanks,
Steve
(CID:133371937)
Posted: 2020-07-04 09:47 PM
This answer was originally posted on DCIM Support by Steven Marchetti on 2018-08-15
Hi Boris,
For DCE, properly setting the locale and time zone under time settings:
...should allow DCE to show the proper time offset for both your region as well as daylight savings specific to that region. You do not need to adjust the server or stop any processes.
I believe it is similar in DCO but I will defer to the DCO experts on that.
Thanks,
Steve
(CID:133371937)
Posted: 2020-07-04 09:47 PM
This comment was originally posted on DCIM Support by Boris on 2018-08-15
Many thanks Steve
(CID:133371953)
Posted: 2020-07-04 09:47 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.