Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Here is how I have it setup:
In DCE I have virtual sensors for active power(Watts) for devices(ie Servers, Cabinets, etc.)
I have DCO configured with our DCE as an external system and I am able to get a list of sensors/devices that I can associate.
When I associate DCE virtual sensors to DCO Devices some of the values show up while others do not.
Why are the sensors behaving differently? They are configured exactly the same and I associated them by dragging and dropping... In the pictures below you will notice under the working one I can see a "Device" listed while under the Not Working one I cannot get this tab.
Working:
Not Working:
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.