EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 06:54 PM
This question was originally posted on DCIM Support by Justin Morgan on 2019-04-30
We uploaded the latest DDF for Chatsworth PDU into our DCE, but we're still unable to pull a history report for current watts being used. Nor do I see any sensor data for total real power in watts listed under device sensors when right clicking on the device.
Is this possible to fix by re-editing the DDF?
(CID:143263787)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 06:54 PM
This comment was originally posted on DCIM Support by Stine Hansen on 2019-06-04
Hi Justin Morgan, sorry for the delay!
Are you still not seeing this issue?,
Thanks,
Stine
(CID:144313684)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 06:55 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.