Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84689members
354048posts

Can i edit polling intervals per sensor on the Netbotz 5.x

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
266

Can i edit polling intervals per sensor on the Netbotz 5.x

This question was originally posted on DCIM Support by Kevin Kolobe on 2019-09-03


Am i able to change polling intervals for universal sensors on the newer Netbotz 5.x?

(CID:148767141)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
266

Re: Can i edit polling intervals per sensor on the Netbotz 5.x

This answer was originally posted on DCIM Support by Steven Marchetti on 2019-09-03


Hi Kevin,

No, you can't set the device to poll sensors at individual times nor can you set DCE to poll individual sensors at specific times.

 

Steve

(CID:148767182)

DCIM_Support
Picard
Picard
0 Likes
0
266

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.