Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84486members
353706posts

Setup/Configure rack-mounted UPS as a power source in DCO

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

Solved
DCIM_Support
Picard
Picard
0 Likes
3
808

Setup/Configure rack-mounted UPS as a power source in DCO

This question was originally posted on DCIM Support by Henry Ng on 2019-09-03


I have an APC Smart-UPS SRT 6000, rack-mountable model and intend to deploy the power path but no POWER option.

Is it possible to setup rack mount UPS as power source in DCO?

My DCO version is 8.2.12-80089-33a247. Thanks!

(CID:148767004)


Accepted Solutions
DCIM_Support
Picard
Picard
0 Likes
1
808

Re: Setup/Configure rack-mounted UPS as a power source in DCO

This answer was originally posted on DCIM Support by Jef Faridi on 2019-09-03


Hi Henry,

Modelling rack-mounted UPS (from the power configuration point of view) in DCO is not supported.

As a workaround using/customizing a floor standing UPS unit could be considered (resize it and place it near the rack).

Kind regards

(CID:148767028)

See Answer In Context

3 Replies 3
DCIM_Support
Picard
Picard
0 Likes
1
809

Re: Setup/Configure rack-mounted UPS as a power source in DCO

This answer was originally posted on DCIM Support by Jef Faridi on 2019-09-03


Hi Henry,

Modelling rack-mounted UPS (from the power configuration point of view) in DCO is not supported.

As a workaround using/customizing a floor standing UPS unit could be considered (resize it and place it near the rack).

Kind regards

(CID:148767028)

DCIM_Support
Picard
Picard
0 Likes
0
808

Re: Setup/Configure rack-mounted UPS as a power source in DCO

This comment was originally posted on DCIM Support by Henry Ng on 2019-09-03


Hi Jef - Seems like that's the only solution (for now?) as I read on similar queries to mine here. Alright. Will try to workaround. Thanks ya!

(CID:148767066)

DCIM_Support
Picard
Picard
0 Likes
0
808

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.