Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84584members
353853posts

Can StruxureWare monitor other vendor products like Vertiv Geist Rack PDU, Switched

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
531

Can StruxureWare monitor other vendor products like Vertiv Geist Rack PDU, Switched

This question was originally posted on DCIM Support by Mr Muro on 2019-11-08


Vertiv Geist Rack PDU, Switched

(CID:151063901)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
529

Re: Can StruxureWare monitor other vendor products like Vertiv Geist Rack PDU, Switched

This answer was originally posted on DCIM Support by Balaraman Jagadeesan on 2019-11-08


Dear Mr Muro,

Yes, it is possible to monitor third party SNMP supported or Modbus Over TCP supported products which include Vertiv. You need to load the appropriate device DDF in DCE software. 

Check these k-base docs which can guide you on this topic.

https://www.apc.com/us/en/faqs/FA290458/

https://www.se.com/in/en/faqs/FA177081/

I hope this helps. 

Regards,

Bala

(CID:151063950)

DCIM_Support
Picard
Picard
0 Likes
0
531

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.