SCADA Pack Configuration

[Mehdi_Sajjadi]

Hi everyone,

I have recently engaged with SCADA Pack RTUs and communicate with GeoSCADA. I have done it from scratch. These are the following setups that I have done on the GeoSCADA side and then exported to Remote Connect. 

In SCADA Pack configuration, there is a DNP3 routing tableource and Destination. SCADA Help was not very clear for me. 

Would you please let me know:

• These source and destination are referring to which of RTU or  GeoSCADA?
• What is a Connect Number? Can we use any arbitrary IP in this section (if we use Ethernet)? 

Thanks in advance.

[sbeadle · Accepted solution]

This is configuration sent to the RTU, so the addressing is as seen from the RTU.

Check Geo SCADA documentation page: Driver Reference > DNP3 SCADAPack E Driver > Configuring DNP3 SCADAPack Tables > Route DNP3 Frames Using a DNP Route Table

And also check the RemoteConnect docs.