Ask the Community
Ask questions, get advice from experts and peers on Digital Automation & Energy Management.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2022-09-28 06:47 AM
É possível disponibilizar para o ONS (Operador Nacional do Sistema Elétrico) do Brasil, através do Power Operation, o protocolo DNP3 ou IEC 104?
Alguém já fez isso pelo Power Operation ou Power Scada Expert 8.2??
Fico no aguardo da resposta,
Obrigado!
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2022-11-03 10:17 AM
Hello @RavichandraH ,
Is it possible to make the DNP3 or IEC 104 protocol available to the ONS (National Electric System Operator) in Brazil, through Power Operation?
Has anyone done this for Power Operation or Power Scada Expert 8.2?
Regards,
Charles
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2022-11-03 08:25 PM
PSE 8.2 supports both protocols, same has been mentioned in PSE Design Guide.
In PSE/PO below drivers needs to be used for these protocols -
Protocol => PSE Driver
DNP3 => DNPR
IEC104 => IEC870IP
For more information on the required driver usage once can refer the driver help
Hope this information helps.
Regards,
Ravi
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.