Ask our Experts
Didn't find what you are looking for? Ask our experts!
Launch of Consumer/Home Owner registration process! We are pleased to announce the commencement of the Consumer/Home Owner Registration Process on Community. Consumers/Home Owners may now proceed to register by clicking on Login/Register. The process is straightforward and designed to be completed in just a few steps.
Support forum to share knowledge about installation and configuration of APC offers including Home Office UPS, Surge Protectors, UTS, software and services.
Search in
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 07:05 AM . Last Modified: 2024-03-21 05:09 AM
Dear all,
We have installed subject UPS in our customer site.
Wiring was done for 3 phase input and supplied to UPS as L1(Red), L2(Yellow), L3(Blue) configuration and the UPS was working fine. But now the customer has changed his mind to use single phase only. In that case can we use the same input by using L1(Red) only and disconnect other phases (L2-Yellow,L3-Blue)?
Thanks & Regards,
STK.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 07:05 AM . Last Modified: 2024-03-21 05:08 AM
Is there any operational impact to the 3Phase UPS when using only 1Phase connected to the 6-Way power Strip?
Can you direct me to any write up?
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 07:05 AM . Last Modified: 2024-03-21 05:08 AM
Yes, you would use L1, neutral and ground only. The link to the manual for this UPS is below. It explains the electrical requirements for both single and 3 phase.
RT10k Manual
http://www.apcmedia.com/salestools/ASTE-6Z8LVK_R5_EN.pdf
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 07:05 AM . Last Modified: 2024-03-21 05:08 AM
Is there any operational impact to the 3Phase UPS when using only 1Phase connected to the 6-Way power Strip?
Can you direct me to any write up?
Link copied. Please paste this link to share this article on your social media post.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.