APC UPS for Home and Office Forum
Support forum to share knowledge about installation and configuration of APC offers including Home Office UPS, Surge Protectors, UTS, software and services.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-10-09 12:02 PM
I have the APC Back-UPS BR1600SI.
The software runs fine except for the Energy Usage tab. I installed it 3 days ago, and Energy Usage is still not updating - still at 0.00kwh usage. Also every now and then the Energy Cost resets to 0 and I have to set it every time. I have the program ran as admin.
I tried reinstalling but issue persists.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-03-01 10:01 PM
Have exactly same problem, did you solve it?
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-03-02 09:14 PM
Uninstalled v3.1.0, installed v3.0.2 and it shows energy usage values
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-03-04 04:44 AM
Install the last version of Power Chute Personal Edition software and report back the results.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.