Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Recommended Forums
Link copied. Please paste this link to share this article on your social media post.
After much research, I just can't seem to figure out how to set up the proper way to setup for a power failure. I am looking to have "Group 1" outlets turn off in the event of a power outage, and the UPS outlets to stay on until the battery runs out of gas. Right now nothing shuts off when I pull the power from it. Attached are the settings I have in the Power Chute software. Can anyone please explain what I'm doing wrong?
Thank you very much in advance!!
Andy
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.