Error F02 on BN 1250G

Notifications

APC UPS for Home and Office Forum

Support forum to share knowledge about installation and configuration of APC offers including Home Office UPS, Surge Protectors, UTS, software and services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

2150

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS for Home and Office Forum

247

Link copied. Please paste this link to share this article on your social media post.

I recently had a problem with the power coming in, which left the server running from the Back-UPS which eventually ran out of juice and powered down. After the problem was fixed everything was powered back up, but about a day and a half later the UPS shut down again with the "Replace Battery" indicator flashing. I replaced the battery and powered it back up, but within a few seconds the alarm started beeping constantly with an "F02" showing. I went through the reset process outlined in http://forums.apc.com/spaces/4/back-ups-surge-protectors/forums/general/12093/bx1000g-gives-f02-erro... of disconnecting everything, holding the power button, reconnect and power back up, but still the same F02. Is this something that can be remedied, or does it mean the original power problem toasted the UPS and I've just spent a lot of money for new batteries for a dead unit?

Dave

Replies 0

To The Top!