Back-UPS ES 700 EBT 1 minute

[Anonymous user]

Hello everyone.

I've recently replaced my battery in Back-UPS ES 700 after several months when I used the UPS only as surge protection with the dead battery inside.

When I finally removed the old battery and connected the new one, I noticed that the PowerChute reported Estimated Battery Time 3 min, all after letting the battery fully charge.

In order to test it, I unplugged the UPS and immediately the PowerChute shown its prepare for hibernation dialog with 10 or so seconds remaining, I cancelled that.

Within 5 or 6 seconds, everything went black, the UPS started to scream (constant beep) and it smelled like something burning (reminded me of painting with temperas in the school years ago).

So I turned turned the UPS off, disconnected all stuff from it and tried again with a simple lamp.

It managed to run for a whole minute until it died again.

I replaced the battery again from an identical UPS which I knew could run on battery for more than 5 minutes.

Guess what, it died after 2 seconds, then after 1 second and now it can't even run without any load (constant beep) while unplugged.

I must say that the previous (new) battery works in the other unit just fine.

Performing brain dead didn't work for me.

How do I fix this aside from buying a new UPC?

Thanks for any help.

Model: Back-UPS ES 700

SN: 5B0652U15819

FW: 829.D2.I

SW: PowerChute Personal Edition 3.0.2

[Anonymous user · Accepted solution]

Hello everyone.

I've recently replaced my battery in Back-UPS ES 700 after several months when I used the UPS only as surge protection with the dead battery inside.

When I finally removed the old battery and connected the new one, I noticed that the PowerChute reported Estimated Battery Time 3 min, all after letting the battery fully charge.

In order to test it, I unplugged the UPS and immediately the PowerChute shown its prepare for hibernation dialog with 10 or so seconds remaining, I cancelled that.

Within 5 or 6 seconds, everything went black, the UPS started to scream (constant beep) and it smelled like something burning (reminded me of painting with temperas in the school years ago).

So I turned turned the UPS off, disconnected all stuff from it and tried again with a simple lamp.

It managed to run for a whole minute until it died again.

I replaced the battery again from an identical UPS which I knew could run on battery for more than 5 minutes.

Guess what, it died after 2 seconds, then after 1 second and now it can't even run without any load (constant beep) while unplugged.

I must say that the previous (new) battery works in the other unit just fine.

Performing brain dead didn't work for me.

How do I fix this aside from buying a new UPC?

Thanks for any help.

Model: Back-UPS ES 700

SN: 5B0652U15819

FW: 829.D2.I

SW: PowerChute Personal Edition 3.0.2