Support forum to share knowledge about installation and configuration of APC offers including Home Office UPS, Surge Protectors, UTS, software and services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-05-1103:54 PM
BE600M1 USB monitoring flapping
Hello,
In the last 24 hours the USB port started flapping, reporting off and on AC every few minutes (a few times in the same second). I have it connected to a Synology NAS, so I am getting hammered by emails and keeping track of this behaviour that way.
Is this something unheard of or a common issue (been searching and couldn't find any reference to this problem for this specific model)?
The UPS is 3 months old and went through a single outage
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-05-1308:38 AM
Sounds like the energy save / sleep is kicking in in the PC. Disable the USB power save / sleep and report back what you see and observe after doing so.
If this resolves the issue please mark this as solved. Lastly, it’s important to replace (temporarily) the USB cable in case it’s faulty as a secondary validation check! ☝️