APC by Schneider Electric BVX1600LI & LEDs interpretation

fjherna · ‎2025-08-19

Hi,

this is first post to the Foro. Sorry for my English (no native).

I have a brand new APC BVX1600LI APU

Very simple APU. My previous APC Backup LS is dead.

It is working apparently well. However at night I found that the green LEDs are too hight.

Is any way in which I could dim the LEDs a little bit or turn of.

Kind regards,

fjherna

Teken · ‎2025-08-19

No method to dim the LED on the unit. Cheap and free options are to use a black sharpie to make the LED darker.

You could also place some Opaque masking tape over the LED.

Questions Ask . . . 👍

Don’t waste my time posting a question on the APC Forums by not responding with the answers or logs when asked!

Because you’re simply a time waster.

Teken · ‎2025-08-19

No method to dim the LED on the unit. Cheap and free options are to use a black sharpie to make the LED darker.

You could also place some Opaque masking tape over the LED.

Questions Ask . . . 👍

Don’t waste my time posting a question on the APC Forums by not responding with the answers or logs when asked!

Because you’re simply a time waster.

fjherna · ‎2025-08-20

Hi Teken

thanks a lot for your prompt response.

I thought that when the unit was totally charged there was a "standby" mode which dimmed LEDs.

I will use your ideas. It is not funny to have a "disco" just close to your bedroom. 🙂

Kind regards,

fjherna

APC by Schneider Electric BVX1600LI &amp; LEDs interpretation