Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84249members
353350posts

APC Battery Backup Model: BGE90M

APC UPS for Home and Office Forum

Schneider Electric support forum for our APC offers including Home Office UPS, Surge Protectors, UTS, software and services and associated products designed to share knowledge, installation, and configuration.

Solved
BillP
Administrator Administrator
Administrator
0 Likes
1
114

APC Battery Backup Model: BGE90M

This question was originally posted by Jack on APC forums on 2/8/2021


My APC model BGE90M started a steady beep about 2:20 A.M. When I went in to check it was emitting a pulsating red light. All the lights on the modem were on. I shut the on/off button on the backup for a second and then pressed it again. The solid green light came on and has remained on and the modem rebooted itself.

Can anyone advise me as to what the problem may be? The only piece of equipment plugged into the backup is the AT&T modem. So it's not overloading. None of the equipment is on.

Any advice would be appreciated.

 


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
114

Re: APC Battery Backup Model: BGE90M

This reply was originally posted by Marcin on APC forums on 2/9/2021


I have the same problem:(

See Answer In Context

1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
115

Re: APC Battery Backup Model: BGE90M

This reply was originally posted by Marcin on APC forums on 2/9/2021


I have the same problem:(