looking for enterprise monitoring solution for ups
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2025-03-0506:44 AM
looking for enterprise monitoring solution for ups
we have back-ups550s that are able to connect to the pc and use powerchute to monitor -- is there an enterprise solution that can monitor all usb connected ups on the network
Link copied. Please paste this link to share this article on your social media post.
Posted: 2025-04-0901:51 AM
Hello,
PowerChute™ Serial Shutdown (PowerChute) provides UPS management, system shutdown, and energy management for devices connected to the UPS, via USB interface.,so it does not allow centerlized platform as no network interface or SNMP protocol based in Back UPS,so each UPS unit had its own PCSS agent installed in PC that protected by each of the units you had,
we had DCE for monitoring APC devices but it should had SNMP V1 or V3 protocol enabled or Modbus TCP which is not a feature in the Back UPS units
Link copied. Please paste this link to share this article on your social media post.
Posted: 2025-04-0901:51 AM
Hello,
PowerChute™ Serial Shutdown (PowerChute) provides UPS management, system shutdown, and energy management for devices connected to the UPS, via USB interface.,so it does not allow centerlized platform as no network interface or SNMP protocol based in Back UPS,so each UPS unit had its own PCSS agent installed in PC that protected by each of the units you had,
we had DCE for monitoring APC devices but it should had SNMP V1 or V3 protocol enabled or Modbus TCP which is not a feature in the Back UPS units
Regards,
Karim
This is a heading
With achievable small steps, users progress and continually feel satisfaction in task accomplishment.
Usetiful Onboarding Checklist remembers the progress of every user, allowing them to take bite-sized journeys and continue where they left.