Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-3002:41 AM. Last Modified: 2024-03-0805:04 AM
fuel power unit for my Smart ups
Hello
I have 8 Smart-UPS RT 8000 RM XL in my Serverroom and plane to buy a power unit (with fuel) which starts after 2 minutes power down.
is there something where I must look specially for the power unti,or can I just add the max Power from each UPS to specify the Power unit.
(like 8000 VA x 8 = we need a fuel Power unit with 64kVA).
(reserves are there enaugh, each UPS has max load 50% and 2 are not in use in the moment)
thanks for answers.
Udo
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-3002:41 AM. Last Modified: 2024-03-0805:04 AM
Hi ich!
When you say power unit, are you talking about a generator?In general, the generator should be 3-5x the size of the total load attached to the generator (Not just the load attached to the UPS.)
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-3002:41 AM. Last Modified: 2024-03-0805:04 AM
Hi ich!
When you say power unit, are you talking about a generator?In general, the generator should be 3-5x the size of the total load attached to the generator (Not just the load attached to the UPS.)