UPS internal temperature custom threshold and the corresponding PCNS event

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Important Note

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

320

Link copied. Please paste this link to share this article on your social media post.

Hello!
Is it possible to set custom internal temperature threshold for the SUA5000 (AP9630), and if the threshold is exceeded, receive the "UPS Temperature Overheated" message (event) on the server with PCNS configured? I changed the temperature threshold in PCBE. The server with the PCBE configured received the corresponding message about the threshold being exceeded and turned off. But PCNS servers connected to the same UPS do not receive such a message. I suspect that they should not, since using PCNS + PCNS is not the right way in this case.

Replies 0

To The Top!

Translating the page…

The page is currently translating. Please wait.