Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2802:59 AM. Last Modified: 2024-02-1410:34 PM
Hi Roberto,
I am thinking you are talking about the main screen of the display showing the 117 volts in. The older models of the display showed the voltage input/output on phase 1, where the recent displays will show the voltages across both phases. This only applies to the "main view" or screen saver, so to speak. As you noted, you can get all of the voltages by going into the status menu.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2802:59 AM. Last Modified: 2024-02-1410:34 PM
Hi Roberto,
I am thinking you are talking about the main screen of the display showing the 117 volts in. The older models of the display showed the voltage input/output on phase 1, where the recent displays will show the voltages across both phases. This only applies to the "main view" or screen saver, so to speak. As you noted, you can get all of the voltages by going into the status menu.