Smart UPS RT 6000 + additional battery

[Anonymous user]

Hi everyone,

I have a Smart UPS RT 6000 and recently I bought an additional battery for it.

I connect the battery to the UPS but I think that it is not working yet, because for example the UPS was still 100% charged after I installed the battery.

I read somewhere (I think in the manual) that I have to "enable" the battery from the control panel of the UPS.

Ok, I went to the web browser interface of the UPS but I can't find any option to enable the battery or something like that..

Can someone tell what to do and where to "enable" the battery of the UPS?

Thx

[BillP]

In your Network Management Card, do you have a blue/white interface with tabs at the top?

If so, go to UPS->Configuration->General and you should have a field in there to add a number. It may say 1 already to count the internal battery so you can bump it to 2.

[Anonymous user]

Ok I found it..just one more question: Does the UPS restart or do something that could disconnect the power supply to the servers attached to it?

[BillP · Accepted solution]

Hi,

The batteries are hot swappable so the UPS will not reboot / restart.