Shutdown single Server with PCNS 3.0 and act on two different UPS

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

291

Link copied. Please paste this link to share this article on your social media post.

Hi,

i've an single Server which should shutdown on the Low-Battery Event from two Smart UPS.
it is working fine with one UPS. But how to setup the second?

Is choosing the parallel mode the right way to listen to two UPS?

Or must i setup multi instance of PCNS? But how in Version 3.0.0? At 2.x there was a question about the number of groups to setup... and does each group shutdown the server and run a script if the connected ups sends the event?

The Server must shutdown if any of the ups sends the event...

Thanks!

Message was edited by: bromberg

Replies 0

To The Top!