Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-09-1009:55 PM
SURTD5000RMXLP3U on-battery no-load watts amps?
Looking for the DC amp draw for a SURTD5000RMXLP3U, on-battery, no-load. Uses RBC140s, 2 sleds, 96v each, 192v total. Prefer measurables, not estimates. Our DC clamp amp meter went bad, waiting on a replacement. Trying to build XL requirements, we've measured the devices, would prefer to know static amps, so we can do the math, for possible extra batteries, pre-gen-set activation.
Other thread states "Based on the online thermal dissipation value listed of 1589 and knowing 1 watt = 3.41BTU, that gives me about ~466 watts you could expect worst case.". That sounds to be 2.43a @ 192v, yet would prefer measurables.