Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Recommended Forums
Free
EnglishData Center Certified Associate Exam Development Path
Strengthen your foundational knowledge in Data Centers for free, enroll in this path today and start your learning journey!
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
When you run a Runtime Calibration you are calibrating the load the available battery/s. The runtime calibration results are posted to the available runtime. Below is a screenshot from a Smart-UPS 700 that shows the runtime at 6 minutes. If I run a Runtime Calibration if there is a change it would be posted here.
Link copied. Please paste this link to share this article on your social media post.
When you run a Runtime Calibration you are calibrating the load the available battery/s. The runtime calibration results are posted to the available runtime. Below is a screenshot from a Smart-UPS 700 that shows the runtime at 6 minutes. If I run a Runtime Calibration if there is a change it would be posted here.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.