PowerChute settings help needed

[Anonymous user]

Hi All

I have a SUA5000 smart-UPS with a AP9617 card, powering 5 servers, communicating with the UPS through a private network hub. All servers are set up as clients in the UPS's Powerchute, communication is fine.

I need the UPS to signal shutdown to all my servers with one of of these 3 events, whichever comes first:

* On battery for 20 minutes
* have 10 minutes left on runtime
* having 10% battery capacity left.

Going through all settings on the UPS, I don't seem to be able to have all that info into the configuration.

Thanks

PS: For clients, I use pcns for windows and mac servers, apcupsd for unix servers (they are much simpler), if this information is of any relevance

Message was edited by: thudn

Message was edited by: thudn

[Anonymous user · Accepted solution]

Hi All

I have a SUA5000 smart-UPS with a AP9617 card, powering 5 servers, communicating with the UPS through a private network hub. All servers are set up as clients in the UPS's Powerchute, communication is fine.

I need the UPS to signal shutdown to all my servers with one of of these 3 events, whichever comes first:

* On battery for 20 minutes
* have 10 minutes left on runtime
* having 10% battery capacity left.

Going through all settings on the UPS, I don't seem to be able to have all that info into the configuration.

Thanks

PS: For clients, I use pcns for windows and mac servers, apcupsd for unix servers (they are much simpler), if this information is of any relevance

Message was edited by: thudn

Message was edited by: thudn