Internal power use (in idle state) of a 9kva Comet Extreme
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2903:06 AM. Last Modified: 2024-03-1303:17 AM
Internal power use (in idle state) of a 9kva Comet Extreme
Hi,
I recently aquired a Comet Extreme 9, including 10 battery units. I'm planning to use the setup as a "whole house" UPS but while testing the equipment I was extremely surprised by the idle power consumption of the UPS itself.
At best, the unit consumes 1kWh, but this peaks at times to 1400w. This is with or without a load attached (240V up/down stream, 5A load).
Is a "internal power use" of 1+kWh a normal figure for this type of UPS?
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2903:06 AM. Last Modified: 2024-03-1303:17 AM
Hi dutchadept, unfortunately the product you are inquiring about is a single phase MGE unit which is owned my EATON (only 3 phase MGE units were taken over by APC). I would suggest reaching out to them (1 800 356 5794) to see if they can further assist. Hope this helps.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2903:06 AM. Last Modified: 2024-03-1303:17 AM
Hi dutchadept, unfortunately the product you are inquiring about is a single phase MGE unit which is owned my EATON (only 3 phase MGE units were taken over by APC). I would suggest reaching out to them (1 800 356 5794) to see if they can further assist. Hope this helps.