ICD and CID File creation

[BillP]

Hi, I have a system that is using a PowerLogic G3200 to convert Allen Bradley MicroLogix 1100 PLC Modbus to IEC 61850, but I am lost when it comes to creating an ICD / CID file for the PLC to load into the G3200.

I have tried absolutely everywhere and all I can find is the PowerLogic user guide and that is not clear.

Does anyone have any experience in doing this?

Can these files be downloaded from anywhere?

Thanks in advance.

ST

[BillP · Accepted solution]

Hi Steve,

Unfortunately, we really only support APC/MGE products here and anything made by Schneider Electric's IT Division.

I believe the Schneider Electric products you're asking about are supported at this community/site: https://community.se.com/ (which as I look, the forums seem to be temporarily down for maintenance.)

Not sure if you've seen this either and if there is any info here: https://community.exchange.se.com/t5/Building-Automation-Knowledge/tkb-p/knowledge-base_public