I can't find description of few OIDs as part of PowerNet-MIB::rPDULoadStatusLoad

[bbiandov_apc]

Hi,

I did look at the PowerNet MIB but I can't see description of:

PowerNet-MIB::rPDULoadStatusLoad.1 = Gauge32: 0
PowerNet-MIB::rPDULoadStatusLoad.2 = Gauge32: 0
PowerNet-MIB::rPDULoadStatusLoad.3 = Gauge32: 0

What is the meaning of 1,2 and 3? Are those banks? If yes which ones? What is 3 for example on a dual bank AP7832 but most of all I would like to know the source which explains those since it isn't in the MIB?

Thank you

~B

[BillP · Accepted solution]

Hi Boyan,

Check out this knowledge base article and let us know if you need anything further than what it explains-> http://www.apc.com/us/en/faqs/FA156142 The 1, 2, and 3 refer to instances as mentioned in the knowledge base article itself.

[bbiandov_apc · Accepted solution]

Thank you very much Angela; in my case (AP7832 single phase, dual bank) the answer was:

Single Phase Multibank PDU

Instance 1: Total Current (Bank 1 + Bank 2)
Instance 2: Total Current on Bank 1
Instance 3: Total Current on Bank 2