How to connect control wires in Symmetra PX 100k?

[BillP]

How to connect control wires in Symmetra PX 100k (SY80K100F)??

Lightsin thePDUare not functioning properly

Manual pag. 44 show is not clear to Connect Comunication wires in installation with PDU:

"Route the four PDU communication cables from the PDU to J7,J8,J9, and J1 on the maintenance bypass interface board (0P3199) in the UPS. But, from PDU (PDPM100F-M) areonlythree wires marked P1, P8, P9

Nowhere in themanual indicateswhichconnect them on 0P3199, P6 on J6 ????

In installation with PDU, must connect jumper wires harness between J1 and J2 ?

if this is correct, then,where it connectsP1 ?

[BillP]

hello. I consulted with our 3 phase power team. They told me this: A Symmetra PX 100k (SY80K100F) is to be installed by a qualified FSE.  The electrician is to only connect power to the PDU and run wires from EPO to the UPS.

So it sounds like an APC FSE should be doing this?

[BillP]

Angela.I´m a FSE from Service Center in Costa Rica, Central America, but we not have service manual of this model, and Users manual is not clear.

[BillP · Accepted solution]

Have you checked with your local tech support team on this? This question should be handled internally per NAM support.