How to Ack/clear site fault warning alert from webgui
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-04-1404:47 AM
How to Ack/clear site fault warning alert from webgui
We recently installed SRT 3000 and every time when we have power outage/power shutdown. The site fault warning alert will pop up and cannot be cleared until we physically going to click "ok" or do the factory reset on the MMC to reconfigure the UPS setting.
Is there any other way we can clear this alarm or any value/setting we should tune?