How do you change the input voltage parameters on UPS' using ISX

Anonymous user · ‎2021-07-01

We have started to receive more and more alerts about low input voltage alarms. I spoke with one of our electricians and he suggested changing the parameters which are currently set at 118.9-122.5v to 114-126v. Can this been accomplished through ISX or would I have to serial into each device?

BillP · ‎2021-07-01

Could you be more specific? Is this ISX Manager or ISX Central or Struxureware Central/Data Center Expert?

Depending what you have, it should be possible and we can look into it further but worst case, you can at least do a mass configuration of this setting outside of "ISX."

See this article: How can I mass configure an Network Management Card (NMC) or NMC embedded product? | FAQs | Schneide...

See Answer In Context

BillP · ‎2021-07-01

Could you be more specific? Is this ISX Manager or ISX Central or Struxureware Central/Data Center Expert?

Depending what you have, it should be possible and we can look into it further but worst case, you can at least do a mass configuration of this setting outside of "ISX."

See this article: How can I mass configure an Network Management Card (NMC) or NMC embedded product? | FAQs | Schneide...